How to create & delete point-to-surface associations in BuildIT

May 26, 2015 BuildIT

 

Occasionally, when using Inspect Geometry in nearest mode, the points can be associated to the wrong surface. This usually happens when inspecting a part with tight corners, where two surfaces can be nearly equidistant from a point.  You can easily correct this by deleting the incorrect association and creating the proper one.

Procedure

A common indication of a badly associated point can be an abnormally large deviation compared to the rest of the part. This happens in workflows where the part was inspected with a rough alignment and was later realigned properly.

Point-to Surface-Association

To ensure that a point is associated to the right surface, simply click on the point to display its list of associations in the General tab of the Object Manager. In this case, the association was made with the vertical surface instead of the correct freeform surface. To delete an association, you only need to right click on the association in the list and select delete measurement association(s).

Point-to-Surface Delete Measurement Associations

Once the incorrect association has been deleted, you will need to create a new one by selecting both the point you’re trying to associate and the surface you wish to associate it to (Hold the Ctrl key to select multiple objects). You can then right-click on the selection in the viewport or the Object Manager and select Create Association.

Point-to-Surface Create Association

Previous Article
3 easy steps to rename multiple entities in BuildIT
3 easy steps to rename multiple entities in BuildIT

There are many reasons to rename multiple entities at a time, however, this will most often occur when you ...

Next Article
Building your first process: getting started with AutomateIT
Building your first process: getting started with AutomateIT

AutomateIT is BuildIT’s process automation tool that enables you to record and reproduce any repetitive pro...

×

Try FARO BuildIT Metrology Today!

First Name
Last Name
Company
Country
State or Province
Zip or Postal Code
Primary Goal
GLOBAL_Opt-In
Access your FREE 7-Day Trial
Error - something went wrong!